Detroit DD13 GHG14 (2014-16) Fault Code: SPN 615 FMI 14 (MCM) Internal or External Leakage of the High Pressure Fuel System
NOTE: The motor control module (MCM) monitors the rail pressure and when a leakage rate is greater than 150 1/h, the MCM sets the code. There is no fault reaction (limp home mode) associated to this code.
POSSIBLE CAUSES:
1. External fuel leakage between the high pressure pump and fuel injectors.
2. High pressure pump (pumping elements).
3. Fuel injector (amplifier or needle) leakage.
4. Pressure limiting valve leakage (internal).
NOTE: The MCM monitors the rail pressure and when a leakage rate is greater than 150 l/h this code is set.
PROBABLE CAUSES:
1. External fuel leakage between the high pressure pump and fuel injectors.
2. High pressure pump.
3. Fuel injector leakage.
4. Pressure limiting valve leakage (internal).
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00
