Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3713 FMI 31 (ACM) High Idle Regeneration Aborted – Low Regeneration Temperature
NOTE: The fault indicates that the high idle regeneration (HIR) was aborted due to the diesel oxidation catalyst (DOC) outlet temperature not reaching the expected target temperature to complete a HIR. If there are any other regeneration or fuel system related faults address those first. The CEL and MIL lamp will remain on until a fault is resolved or a successful regeneration is completed.
POSSIBLE ISSUES:
1. Low fuel compensation pressure.
2. Exhaust leaks.
3. Fuel leaks.
4. Sticking hydrocarbon (HC) doser injection valve (High doser line pressure).
5. DOC outlet temperature not responding.
PROBABLE CAUSES:
1. Low fuel compensation pressure.
2. Exhaust leaks.
3. Fuel leaks.
4. Sticking hydrocarbon (HC) doser injector valve.
5. High doser line pressure.
6. DOC outlet temperature sensor or connector/harness.
![JOHN DEERE PARTS ADVISOR & HITACHI 2.24.2 [2023.07] - ECUFORCETRUCK EPC](https://www.ecuforcetruck.com/wp-content/uploads/2023/09/1-300x300.png)
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://www.ecuforcetruck.com/wp-content/uploads/2023/11/1-300x300.png)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
