Detroit DD13 GHG14 (2014-16) Fault Code: SPN 3711 FMI 31 (MCM) High Idle Regeneration (Aborted) – Low Exhaust Temperature
NOTE: The fault indicates that the High Idle Regeneration (HIR) was aborted due to the Diesel Oxidation Catalyst (DOC) inlet temperature not reaching the minimum of 270°C (518°F) to initiate dosing during an HIR. The CEL and MIL lamps will remain ON until the fault is resolved or a successful regeneration is completed.
NOTE: Please see the step by step troubleshooting procedures for this specific code.
NOTE: If codes 3242-xx exist, fix those first.
PROBABLE CAUSES:
1. Intake throttle valve failure.
2. Exhaust leaks.
3. Intake manifold leaks.
4. Charge air cooler leaks.
5. Jake brake operation (Not turning on).
6. DOC inlet temperature sensor.
7. ECM failure.
8. Jack brake rocker arm shaft not installed properly or failed.
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://i0.wp.com/www.ecuforcetruck.com/wp-content/uploads/2023/11/1.png?resize=300%2C300&ssl=1)
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00
