Detroit DD13 GHG14 (2014-16) Fault Code: SPN 2797 FMI 4 (MCM) Fuel Injector Needle Control Valve Cylinder 1, 2, 3 Shorted to Ground
DESCRIPTION:
Injector needle control valve cylinder 1, 2, 3 shorted to ground.
MONITORED PARAMETER:
Injector needle control valve cylinder 1, 2, 3.
TYPICAL ENABLING CONDITIONS:
Engine rpm = Idle or higher.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous when enabling conditions met.
TYPICAL DURATION:
Two seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
Derate 25%
VERIFICATION:
Engine Idle: One minute.
NOTE: Remove rocker cover and disconnect 1 injector at a time. Measure resistance between pin #3 of injector and ground. If more than 3 ohms, replace the injector.
PROBABLE CAUSES:
1. Injector 1, 2, or 3.
2. Short to ground between pin 25 of the 120-pin ECM connection and pin 1 of the front fuel injector harness (14-pin) connector.
3. Failed MCM (Engine ECM).
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://i0.wp.com/www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A.jpg?resize=300%2C300&ssl=1)
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
