Detroit DD13 GHG14 (2014-16) Fault Code: SPN 1639 FMI 2 (MCM) Fan Speed Error
DESCRIPTION:
This code sets when a fan speed deviation is detected.
MONITORED PARAMETER:
Fan speed sensor.
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
Two seconds
DASH LAMPS:
CEL
ENGINE REACTION:
None
VERIFICATION:
Engine running with fan engaged.
NOTE: If 1071-5 or 647-5 active, repair the wiring between pin 91 (from the 120 pin ECM connector) and the fan and the jake brake solenoids.
PROBABLE CAUSES:
1. Coolant loss.
2. Thermostat failure.
3. Bloackage in radiator and charge air cooler.
4. Fan belt condition.
5. Proper location of fan shroud.
6. Proper radiator hose condition.
7. Fan failure.
8. Short between fan speed sensor and ECM.
9. Fan drive failure.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
