Detroit DD13 GHG14 (2014-16) Fault Code: SPN 1322 FMI 31 (MCM) Multiple Cylinder Misfire Detected at Idle
The Entry Conditions For This Code Are:
1. Engine speed is above low idle.
2. All cylinders are active, no fault reactions.
3. Engine speed/torque is steady.
This Fault Can Occur Due To The Conditions Listed Below:
1. Cylinder kit failure.
2. Valve train failure.
3. Lash adjustments.
4. Fuel injector.
5. High pressure fuel line (Rail to fuel injector).
6. Debris entering fuel injector (intermittent faults).
7. Fuel quality.
PROBABLE CAUSES:
1. Cylinder kit failure.
2. Valve train failure.
3. Lash adjustments.
4. Fuel injector.
5. High pressure fuel line (rail to fuel injector).
6. Debris entering fuel injector.
7. Fuel quality.
Note: If 1322-31 active, fix that first.
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://www.ecuforcetruck.com/wp-content/uploads/2023/11/1-300x300.png)
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
