Detroit DD13 EPA10 (2010-13) Fault Code: SPN 654 FMI 3 (MCM) Injector Cylinder #4 Needle Control Valve Abnormal Operation (MAX)
DESCRIPTION:
This code will set when the Needle solenoid current response time does not meet requirement.
MONITORED PARAMETER:
Injector cylinder #4 needle control valve Current.
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Continuous
TYPICAL DURATION:
.02 msec
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
1. Derate 25%.
2. EGR Valve shut.
3. DPF Inhibit Regeneration.
VERIFICATION:
Engine Idle: One minute.
NOTE: If code 168-xx or 723-xx present, fix those first.
PROBABLE CAUSES:
1. Front fuel injector harness connection (14-pins).
2. Injector harness.
3. Failed injector.
4. Engine side harness failure.
5. MCM (Engine ECM) failure.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
-
