Detroit DD13 EPA10 (2010-13) Fault Code: SPN 3597 FMI 4 (ACM) Proportional Valve Bank 1 Circuit Failed Low
NOTE: High side digital output 1 is the voltage supply to the following components:
1. Diesel Exhaust Fluid (DEF) Pump.
2. Metering Unit.
3. Diffuser Heater and the DEF Injection Valve.
DESCRIPTION:
Proportional valve bank 1 circuit failed low.
MONITORED PARAMETER:
Motor Control Module (MCM) internal power supply.
TYPICAL ENABLING CONDITIONS:
Always Enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always Enabled
TYPICAL DURATION:
Two second
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
None
VERIFICATION:
Engine Idle (1 minute).
PROBABLE CAUSES:
For 2007 EPA Engines:
1. Engine brake solenoid.
2. Short to ground between pin 91 of the ECM 120-pin connector and the valve cover fuel injector harness connector (31-pin connector).
3. Short to ground between pin 22 of the 31-pin connector on the vehicle side of he harness and the fan control solenoid.
4. Short to ground between pin 93 of the ECM 120-pin connector and the air seal pressure regulator valve cover.
5. Failed air seal pressure regulator valve.
For 2010 EPA Engines:
1. Inspect the connectors on: DEF pump, pressure limiting unit, diffuser heater, and DEF injection valve.
2. ACM2 (Aftertreatment Control Module) failure.
3. Short to ground between pins 1, 3, or 5 of the ACM2 and pin 2 of the corresponding components.
4. Reconnect components from line #1 one at a time and clear the code after each connection. When the code goes active, this is your failed part.
For 2014 EPA Engines:
1. Engine jake brake solenoid failure.
2. Front under valve cover fuel injector harness.
3. Short to ground between pin 91 of the 120-pin ECM connection and the valve cover fuel injector harness connector (31-pin).
4. Short to ground between pin 22 of the 31-pin connector on the vehicle side of the harness and fan control solenoid.
5. Short to ground between pin 93 of the 120-pin ECM connection and the air seal pressure regulator valve connector.
6. Air seal pressure regulator valve.
Related
-
download Hitachi Construction Machinery MPDr Ver 3.7.0.0 [10.2020] Diagnostic Software
Hitachi $76.00Rated 0 out of 5
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 P0719 Brake Switch ABS Input Low
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0880 TCM Supply Voltage
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1016 Class 2 J1850 (Class 2) Powertrain Controller State of Health Failure
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0871 Transmission Pressure Switch Solenoid E Circuit Stuck Open
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2810 Solenoid G Electrical
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0847 Transmission Pressure Switch Solenoid D Circuit Stuck Closed
1000 & 2000 Gen 4 $50.00Rated 0 out of 5 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1891 Engine Throttle Position Sensor Pulse Width Modulation (PWM) Signal Low Input
1000 & 2000 Gen 4 $50.00Rated 0 out of 5
-
SERVICE MANUAL Carrie Starbird TDB/TDS-215 and Starbird PlusTDB/TDS-219
CARRIE $24.00Rated 0 out of 5