Detroit DD13 EPA10 (2010-13) Fault Code: SPN 2630 FMI 16 (MCM) Charge Air Cooler Performance Monitor
DESCRIPTION:
This code sets when the actual Charge Air Cooler temperature is higher than the modeled Charge Air Cooler Temperature.
MONITORED PARAMETER:
Charge air cooler outlet temperature sensor.
TYPICAL ENABLING CONDITIONS:
1. Engine speed 1200 to 1950 rpm.
2. Engine torque greater than 1000 N·m (737 lb·ft).
3. Intake manifold temperature less than 100°C (212°F).
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
10 seconds
DASH LAMPS:
1. MIL
2. CEL
ENGINE REACTION:
Derate 10%
VERIFICATION:
Obtain enabling conditions on a chassis dyno or by driving unloaded vehicle for more than 20 seconds.
POSSIBLE CAUSES:
1. Low vehicle speed with high engine load.
2. External CAC restriction (such as a plow, grill winter front or dirt).
3. Internal CAC restriction.
PROBABLE CAUSES:
1. Low vehicle speed with high engine load (steep grade climb).
2. Fan operation.
3. Winter front in high ambient temperatures.
Related products
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
