Detroit DD13 EPA10 (2010-13) Fault Code: SPN 110 FMI 14 (MCM) Coolant Temperature/Engine Oil Temperature Plausibility Fault
DESCRIPTION:
Coolant temperature/engine oil temperature plausibility fault.
MONITORED PARAMETER:
Coolant outlet and oil temperature sensors.
TYPICAL ENABLING CONDITIONS:
1. Oil temperature greater than 65°C.
2. Engine running for greater than 1200 seconds.
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
30
DASH LAMPS:
MIL
VERIFICATION:
1. Warm up engine such that oil temperature is greater than 65°C.
2. Run for 1200 seconds.
NOTE: If other cooling system faults or issues present, fix those first.
PROBABLE CAUSES:
1. Low engine oil level.
2. Engine coolant thermostat failure.
3. Coolant outlet sensor and/or oil temperature sensor harness.
4. Coolant outlet sensor and/or oil temperature sensor.
Related products
-
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00
