Detroit DD13 EPA10 (2010-13) Fault Code: SPN 100 FMI 4 (MCM) Engine Oil Pressure Sensor Circuit Failed Low
NOTE: If diagnostic leads to a mechanical (non-electrical) low oil pressure conditions, all mains and connecting rods should be inspected.
NOTE: If 100-4, 94-4, 4407-4, 3609-4, and 3610-4 are present, repair the short to ground between pins 82 of the 120-pin ECM connector and the engine oil, hydrocarbon doser fuel line, hydrocarbon doser fuel compensation sensor, DPF inlet, and DPF outlet pressure sensors.
NOTE: If 100-4, 94-4, and 4407-4 are present, repair the open between pin 82 of the 120-pin ECM connection and the engine oil, doser fuel line, and doser fuel compensation sensors.
PROBABLE CAUSES:
1. Engine oil pressure sensor connector/harness.
2. Engine oil pressure sensor.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
