Detroit DD13 EPA07 (2007-09) Fault Code: SPN 3509 FMI 3 (MCM) The 5V Sensor Supply Bank 1 Circuit Failed High
NOTE: This fault indicates that the Motor Control Module (MCM) detects a short to power (voltage greater than 5.3) on any of the MCM pins, which are listed in the chart below. Inspect the harness and repair as necessary. Verify repairs.
PROBABLE CAUSES:
1. Disconnect these sensors one at a time. If code goes inactive, replace component: Crank case ventilator speed sensor, intake manifold pressure sensor, fuel rail pressure sensor, water pump speed sensor, hydrocarbon doser pressure in sensor, hydrocarbon doser pressure out sensor, oil pressure sensor, camshaft position sensor, fan speed sensor, EGR delta P sensor, intake throttle valve, PLOP fuel pressure sensor.
2. Engine sensor harness.
3. MCM2.1 (Engine ECM).
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00
