Detroit DD13 EPA07 (2007-09) Fault Code: SPN 110 FMI 0 (MCM) Coolant Temperature High
DESCRIPTION:
This code sets once the motor control module (MCM) detects that the outlet coolant temperature is above 112°C (234°F).
MONITORED PARAMETER:
Engine coolant outlet temperature sensor.
TYPICAL ENABLING CONDITIONS:
Always enabled
MONITOR SEQUENCE:
None
EXECUTION FREQUENCY:
Always enabled
TYPICAL DURATION:
Two seconds
DASH LAMPS:
1. MIL
2. CEL
VERIFICATION:
Outlet coolant temperature above 112°C (234°F) followed by one minute of idling.
NOTE: If codes 110-3 or 110-4 also active, fix those first.
NOTE: With a code engine, coolant inlet and coolant outlet temperature should be within 25 degree’s of each other. If not, replace both sensors.
Otherwise, most PROBABLE failures are:
1. Low coolant.
2. Thermostat failure.
3. Blockage in radiator and/or charge air cooler.
4. Fan belt failure.
5. Fan shroud failure or installed improperly.
6. Radiator hose failure (collapsed hoses).
7. Engine fan failure.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00
