Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 8214 PID: SPN: 521218 FMI: 3/3 Connectivity Module GPS External Antenna – Voltage Above Normal or Shorted to High Source

Lamp:
None

Reason:
An error with connectivity module has been detected.

Effect:
None on performance.

Circuit Description:
The connectivity module is a data logging device. The connectivity module system collects data from the ECM via the vehicle J1939 network.
The connectivity module is also a predictive cruise control system. The predictive cruise control system sends commands to the ECM via the vehicle J1939 network. Predictive cruise control dynamically adjust the vehicle speed profile while the vehicle is operating in cruise control. The vehicle speed profile is optimized for fuel economy based on the upcoming road grade.

Component Location:
The connectivity module is either located on the engine or in the vehicle cabin.

Conditions for Running the Diagnostic:
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes:
The connectivity module reported an internal error of the connectivity module.

Action Taken When the Fault Code is Active:
1. The ECM logs the fault code immediately when the diagnostic runs and fails.
2. The connectivity module may not operate.

Conditions for Clearing the Fault Code:
1. To validate the repair, perform a key cycle, start the engine and let it idle for 2 minute.
2. The fault code status displayed by the recommended diagnostic tool or equivalent will change to inactive immediately after the diagnostic runs and passes.

Shop Talk:
Possible causes of this fault code include:
A malfunctioning connectivity module.