Cummins ISX15 CM2250 (2010-12) Fault Code: 3382 PID: SPN: 3058 FMI: 18 Engine Exhaust Gas Recirculation (EGR) System- Data Valid But Below Normal Operating Range- Moderately Severe Level

Circuit Description
The engine control module (ECM) uses the EGR differential pressure sensor reading to determine how much exhaust gas is flowing through the EGR connection tube to the intake manifold. The EGR differential pressure sensor measures the pressure drop across the EGR differential pressure orifice using two exhaust ports. The sensor outputs a voltage, which represents the pressure difference between the two ports, and the ECM correlates that voltage to an EGR flow rate. This information is used to control the EGR valve for correct emission levels.

The ECM provides a 5 volt supply to the EGR differential pressure sensor on the sensor supply circuit. The ECM also provides a ground on the sensor return circuit. The EGR differential pressure sensor provides a signal to the ECM on the EGR differential pressure sensor signal circuit. This sensor signal voltage changes, based on the differential pressure in the EGR crossover tube.

Component Location
The EGR valve and EGR differential pressure sensor could be located on either side of the engine.

Conditions for Running the Diagnostics
This diagnosic runs when the engine is operating and has reached normal operating tempertures (coolant temperature above 60?C [140?F] ), and the EGR valve is open. The EGR valve position can be monitored using INSITE? electronic service tool.

Conditions for Setting the Fault Codes
The ECM determines that the actual EGR flow is lower than what is being commanded based on the current engine operating conditions.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or malfunciton indicator lamp (MIL) immediately when the diagnostic runs and fails for two consecutive trips.

Conditions for Clearing the Fault Code
To validate the repair using a Diagnostic Road Test, utilize a route that incorporates both stop-and-go city driving and steady state highway driving. It may be necessary to load the unit for certain diagnostics in the ECM to run.
To validate the repair using a Chassis Dynamometer Test, utilize a routine that incorporates acceleration and motoring events, steady state highway operation, and load. This will simulate normal driving and allow the diagnostics in the ECM to run.
The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp after the diagnostic runs and passes.
For On-Board Diagnostic (OBD) engines, the ECM will turn off the MIL after three consecutive trips where the diagnostic runs and passes.
The ?Reset All Faults? command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
Possible causes of this fault code are:

Leaks or restrictions in the EGR flow plumbing
Internally leaking EGR valve
Stuck closed EGR valve
Malfunctioning EGR differential pressure sensor.

Possible Cause:
1) EGR orifice pressure sensor failure
2) ECM failure