Cummins ISX CM870 (2003-06) Fault Code: 482 PID: P094 SPN: 94 FMI: 1/18 Fuel Pressure Low – Data Valid But Below Normal Operating Range – Moderately Severe Level.
The fuel pressure is monitored by the ECM. If the rail fuel pressure is lower than an acceptable level for a given set of engine operating conditions, the fault code is logged.
Possible causes:
1)A damaged or sticking drain-back valve located in the fuel supply circuit in the integrated fuel system module (IFSM). The IFSM is located directly above the fuel lift pump.
Possible repairs:
1)Fill the fuel tanks.
2)Prime the fuel system.
3)Repair or replace the fuel lift pump.
4)Repair or replace the fuel shutoff valve.
5)Replace the 1724 kPa [250 psi] regulator.
6)Replace the suction-side fuel filter or repair the cause of high inlet restriction.
7)Repair or replace the fuel shutoff valve.
8)Replace the pressure fuel filter.
9)Replace the rail fuel pressure sensor.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00
