Cummins ISM CM875 (2003-06) Fault Code: 9121 PID: S146 SPN: 2791 FMI: 0/15 EGR Valve Actuator Over Temperature (Calculated) – Data Above Normal Range – least severe level.
The ECM calculates the temperature of the EGR valve motor. If the ECM detects excessive temperatures for a calibrated period of time this fault is recorded and the valve is commanded closed. This action is for protection of the valve only; this fault code is not indicative of any component failure. Once the ECM detects normal EGR valve temperatures, the fault code will go inactive and the EGR valve operation will resume.
NOTE: During this event, there will be no noticeable symptoms. This troubleshooting tree should not be considered if there is a performance complaint.
A combination of frequent valve movement and elevated coolant temperatures can lead to this fault code.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00
