Cummins ISM CM875 (2003-06) Fault Code: 2963 PID: P110 SPN: 110 FMI: 0/16 Engine Coolant Temperature – Data Valid But Above Normal Operating Range – Least Severe Level. Engine coolant temperature is above the engine protection warning limit.
The engine coolant temperature sensor measures the temperature of the engine coolant as it passes through the thermostat housing. This fault code is activated if the engine coolant temperature is above 107?C [225?F] for at least five seconds.
Possible causes:
1)Obstructed radiator
2)Plugged vent lines
3)Aerated coolant
4)Other cooling system failure.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
-
