Cummins ISM CM875 (2003-06) Fault Code: 254 PID: S017 SPN: 632 FMI: 4/4 Fuel Shutoff Valve Circuit – Shorted Low. Low voltage detected at fuel shutoff valve circuit.
Inspect the fuel shutoff supply circuit for external wires that can be spliced in to power another device. Remove any extra wires that are found in the circuit. If there is an external shutdown system on the vehicle that uses the fuel shutoff valve for engine shutdown, make sure it has not failed and pulled down the voltage on the fuel shutoff circuit. Inspect the engine-to-chassis ground wire to make sure it is securely fastened to a clean, dry, conductive surface.
Possible causes:
1)Short circuit to ground in the engine harness, connectors, or fuel shutoff valve.
Possible repairs:
1)Replace the fuel shutoff valve.
2)Replace the fuel shutoff valve solenoid.
3)Replace the ECM.
4)Repair or replace the engine harness.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00
