Cummins ISM CM875 (2003-06) Fault Code: 214 PID: P175 SPN: 175 FMI: 0/0 Engine Oil Temperature – Data Valid But Above Normal Operating Range – Most Severe Level. Engine oil temperature signal indicates engine oil temperature above engine protection critical limit.
The engine oil temperature sensor measures the temperature of the oil in the oil rifle on the left hand side of the engine block. This fault code is activated if the engine oil temperature is above 122?C [252?F].
Possible causes:
1)Low oil level
2)High coolant temperature
3)Failed lubricating oil thermostat
4)Failed lubricating oil cooler
5)Failed engine oil temperature sensor.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
