Cummins ISM CM870 (2003-06) Fault Code: 778 PID: S64 SPN: 723 FMI: 2/2 Engine Camshaft Speed / Position Sensor – Data Erratic, Intermittent, or Incorrect.? The ECM has detected a loss of signal from the camshaft position sensor.
This fault is logged when the ECM does not receive a valid camshaft position signal.
Possible repairs:
1)Open or short circuit of the +5 volt supply, signal, or return wire in the engine harness
2)Damaged or failed camshaft position sensor.
Possible repairs:
1)Replace the engine wiring harness.
2)Replace the camshaft position sensor.
3)Inspect the camshaft tone wheel/gear teeth for damage or spinning.
4)Replace the ECM.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
