Cummins ISM CM870 (2003-06) Fault Code: 287 PID: P091 SPN: 19 FMI: 19 SAE J1939 Multiplexing Accelerator Pedal Sensor Error. The OEM vehicle electronic control unit (VECU) detected a fault with its accelerator pedal.
If the OEM vehicle electronic control unit detects an error with the accelerator pedal sensor, it transmits an error message to the ECM. This fault code is set active when the ECM receives an accelerator pedal sensor error message from the vehicle electronic control unit over the SAE J1939 data link.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00
