Cummins ISL CM850 (2003-06) Fault Code: 352 PID: SID 212 SPN: 1079 FMI: 4 Sensor Supply Voltage Number 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at sensor supply number 1 circuit.

Cummins ISL CM850 (2003-06) Fault Code: 352 PID: SID 212 SPN: 1079 FMI: 4 Sensor Supply Voltage Number 1 Circuit – Voltage Below Normal or Shorted to Low Source. Low voltage detected at sensor supply number 1 circuit.

Low voltage on the (+) 5 volt supply line can be caused by a short circuit to ground in a supply line, a short circuit between a supply line and a return line, a failed sensor, or a failed ECM power supply.

On-Board Diagnostics (OBD) Information (Euro 4 Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)The ECM turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. The MIL lamp and fault code can also be cleared using the INSITE? electronic service tool.
3)The fault code will be cleared from memory after 40 consecutive drive cycles where the diagnostic runs and passes.

On-Board Diagnostics (OBD) Information (Euro 4 Stage 1+ Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)An engine torque derate will be activated after 50 hours of engine operation with the fault code active.
3)The ECM turns OFF the malfunction indicator lamp (MIL) after 1 ignition cycle that the diagnostic runs and does not fail. The MIL lamp cannot be cleared using the INSITE? electronic service tool.
4)The fault code will be cleared from memory after 400 days or 9600 hours of engine operation.

Possible repairs:

1)Replace the barometric pressure sensor.
2)Repair or replace the engine harness with the damaged pins.
3)Replace the engine coolant temperature sensor.
4)Replace the EGR temperature sensor.
5)Replace the turbocharger speed sensor.
6)Repair or replace the engine harness with the damaged pins.
7)Replace the turbocharger position sensor
8)Replace the OEM pressure sensor.
9)Replace the digital vehicle speed sensor.
10)Replace the remote accelerator position sensor.
11)Replace the ECM.
12)Replace the OEM harness.