Cummins ISL CM850 (2003-06) Fault Code: 2217 PID: SID 240 SPN: 630 FMI: 111 Engine Control Module Calibration Program Memory (RAM) Corruption – Condition Exists. Severe loss of data from the ECM.
Cummins ISL CM850 (2003-06) Fault Code: 2217 PID: SID 240 SPN: 630 FMI: 111 Engine Control Module Calibration Program Memory (RAM) Corruption – Condition Exists. Severe loss of data from the ECM.
On-Board Diagnostics (OBD) Information (Euro 4 Certified Engines):
1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)The ECM turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. The MIL lamp and fault code can also be cleared using the INSITE? service tool.
3)The fault code will be cleared from memory after 40 consecutive drive cycles where the diagnostic runs and passes.
On-Board Diagnostics (OBD) Information (Euro 4 Stage 1+ Certified Engines):
1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)An engine torque derate will be activated after 50 hours of engine operation with the fault code active.
3)The ECM turns OFF the malfunction indicator lamp (MIL) after 1 ignition cycle that the diagnostic runs and does not fail. The MIL lamp cannot be cleared using the INSITE? service tool.
4)The fault code will be cleared from memory after 400 days or 9600 hours of engine operation.
Possible repairs:
1)Charge or replace the battery.
2)Tighten the loose connections and clean the terminals.
3)Replace the fuses.
4)Repair or replace the OEM harness.
