Cummins ISC CM2150 (2007-09) Fault Code: 334 PID: 110 SPN: 100 FMI: 2 Engine Coolant Temperature – Data Erratic, Intermittent, or Incorrect. The engine coolant temperature reading is not changing with engine operating conditions.
Verify the electronic control module (ECM) calibration is correct. Check the calibration revision history found on QuickServe® Online for applicable fixes to the calibration stored in the ECM. If necessary, recalibrate the ECM.
Two different failure modes of the engine coolant temperature sensor can trigger this fault code. Either the sensor is not reading ambient air temperature after an extended period with the engine not running or the engine coolant temperature is not changing with engine operating conditions.
Possible causes:
1)Stuck in-range engine coolant temperature sensor
2)High resistance in the engine coolant temperature sensor signal or return lines.
Possible repairs:
1)Replace the thermostat.
2)Replace the engine coolant temperature sensor.
3)Replace the ECM.
4)Repair or replace the engine harness.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
