Cummins ISC CM2150 (2007-09) Fault Code: 1899 PID: 411 SPN: 411 FMI: 1 Exhaust Gas Recirculation (EGR) Valve Delta Pressure – Data Valid But Above Normal Operating Range – Moderately Severe Level. The EGR differential pressure sensor has detected low EGR gas flow or the EGR differential pressure reading is not valid for engine operating conditions.
Verify the ECM calibration is correct. Check the calibration revision history found on QuickServe™ Online for applicable fixes to the calibration stored in the ECM. If necessary, calibrate the ECM.
This diagnostic checks the EGR differential pressure sensor reading when the EGR valve is open. Since the EGR valve is open, the reading of the EGR differential pressure must be greater than zero. If the ECM detects a reading lower than expected with the EGR valve open, this fault code is logged.
Possible causes:
1)A malfunctioning EGR differential pressure sensor
2)A stuck closed EGR valve
3)EGR differential pressure sensor flow port cross-drillings are plugged with soot or shellac
4)A fouled EGR cooler.
Possible repairs:
1)Clean the EGR differential pressure sensor flow ports.
2)Clean the EGR cooler.
3)Replace the EGR delta pressure sensor.
4)Repair or replace the engine harness.
5)Replace the ECM.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00
