Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6256 PID: SPN: 168 FMI: 15 Battery 1 Voltage – Data Valid But Above Normal Operating Range – Least Severe Level. ECM supply voltage is above the maximum system voltage level.

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 6256 PID: SPN: 168 FMI: 15 Battery 1 Voltage – Data Valid But Above Normal Operating Range – Least Severe Level. ECM supply voltage is above the maximum system voltage level.

Circuit Description
The engine control module (ECM) receives constant voltage from the batteries through the unswitched battery wires that are connected directly to the positive (+) battery post. The ECM receives switched battery input through the keyswitch wire when the keyswitch is turned ON.

Component Location
The ECM is connected to the battery by the OEM harness. This direct link provides a constant power supply for the ECM. The location of the battery will vary with the original equipment manufacturer (OEM). Refer to the OEM service manual.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected excessive battery supply voltage.

Action Taken When the Fault Code is Active
The ECM logs the fault code immediately when the diagnostic runs and fails.

Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, and leave the key in the ON position for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Possible Causes:
1)Faulty alternator or regulator that is overcharging the system
2)Batteries connected in series instead of parallel
3)Incorrect jump-starting procedure.
4)Reference the appropriate OEM wiring diagram when troubleshooting circuits that utilize wiring supplied by the OEM.