Cummins ISB6.7 CM2350 (2013-17) Fault Code: 1715 PID: SPN: 3364 FMI: 11 Aftertreatment Diesel Exhaust Fluid Quality- Root Cause Not Known
Cummins ISB6.7 CM2350 (2013-17) Fault Code: 1715 PID: SPN: 3364 FMI: 11 Aftertreatment Diesel Exhaust Fluid Quality- Root Cause Not Known
Circuit Description
The aftertreatment diesel exhaust fluid quality sensor is a smart device that communicates to the ECM via the J1939 datalink. The aftertreatment diesel exhaust fluid quality sensor performs its own internal diagnostics and reports malfunctions back to the primary engine control module via the J1939 datalink. The aftertreatment diesel exhaust fluid quality sensor is used to measure the concentration of the aftertreatment diesel exhaust fluid in the tank.
Component Location
The aftertreatment diesel exhaust fluid quality sensor is located in the aftertreatment diesel exhaust fluid tank. It may be a combination sensor with the aftertreatement diesel exhaust fluid tank level and tank temperature sensors. Location of the tank and sensor is OEM dependent. Refer to the OEM service manual.
Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.
Conditions for Setting the Fault Codes
The DEF quality sensor has reported an internal error.
Action Taken When the Fault Code is Active
1)The ECM will illuminate the amber CHECK ENGINE light immediately when the diagnostic runs and fails.
2)Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
1)To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
2)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
3)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults.
4)The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
Possible cause:
1) Malfunctioning Aftertreatment DEF Quality Sensor.
