Cummins ISB6.7 CM2350 (2013-17) Fault Code: 155 PID: 105 SPN: 105 FMI: 0 IntakeManifold 1 Temperature- Data Valid But Above Normal Operating Range- Most Severe Level

Cummins ISB6.7 CM2350 (2013-17) Fault Code: 155 PID: 105 SPN: 105 FMI: 0 IntakeManifold 1 Temperature- Data Valid But Above Normal Operating Range- Most Severe Level

Circuit Description
The Engine Control Module (ECM) provides 5 volts to the intake manifold temperature signal circuit, and monitors the change in voltage caused by changes in the resistance of the sensor to determine the intake manifold temperature. When the intake air is cold, the sensor (or thermistor) resistance is high. The ECM signal voltage only pulls down a small amount through the sensor to a ground. Therefore, the ECM senses a high signal voltage or low temperature. When the intake air is warm, the sensor resistance is low. The signal voltage pulls down a large amount. Therefore, the ECM senses a low signal voltage, or a high temperature.

Component Location
The intake manifold 1 pressure/temperature sensor is located in the air intake horn.

Conditions for Running the Diagnostics
This diagnostic runs continuously when the keyswitch is in the ON position or when the engine is running.

Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected the intake manfiold air temperature was greater than 132?C [270?F] for 5 seconds.

Action Taken When the Fault Code is Active
1)The ECM illuminates the red STOP ENGINE lamp immediately after the diagnostic runs and fails.
2)The torque output of the engine will be reduced.
3)Maximum engine operating speed will be decreased.
4)The engine will be shut down if the Engine Protection Shutdown feature is enabled.

Conditions for Clearing the Fault Code
1)To validate the repair using a Diagnostic Road Test, utilize a route that incorporates both stop and go city type driving and steady state highway type driving. It may be necessary to load the unit for certain diagnostics in the ECM to run.
2)To validate the repair using a Chassis Dynamometer, utilize a routine that incorporates acceleration and motoring events, steady state highway type operation, and load. This will simulate normal driving and allow the diagnostics in the ECM to run.
3)The fault code status displayed by INSITE? electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
4)The ECM will turn off the red STOP ENGINE lamp immediately after the diagnostic runs and passes.
5)The Reset All Faults command in INSITE? electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
The intake manifold air temperature sensor measures the temperature of the charge-air as it passes through the intake manifold.

Possible causes:
1) Restricted air flow through the charge-air cooler
2) Undersized charge-air cooler
3) High turbocharger compressor outlet temperature.