Cummins ISB4.5 CM2150 Fault Code: 478 PID: 444 SPN: 444 FMI: 0 Battery 2 Voltage – Data Valid but Above Normal Operating Range – Moderately Severe Level.

Circuit Description
The aftertreatment diesel exhaust fluid controller communicates with the ECM and controls the heating, dosing, and purging of the aftertreatment diesel exhaust fluid system.

Component Location
The aftertreatment diesel exhaust fluid controller is installed on the vehicle by the OEM. Refer to the OEM Service Manual for component location.

Conditions for Running the Diagnostics
-This diagnostic runs continuously when the keyswitch is in the ON position.

Conditions for Setting the Fault Codes
-The aftertreatment diesel exhaust fluid controller detects the battery supply voltage is greater than a threshold.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.

Conditions for Clearing the Fault Code
The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs a passes.

The ECM will turn off the MIL after 3 consecutive trips where the diagnostic runs and passes.

Possible Causes
– Improper battery voltage setting in INSITE electronic service tool