Cummins ISB CM850 (2003-06) Fault Code: 1669 PID: SPN: 1761 FMI: 3 Catalyst Tank Level Sensor Circuit ? Voltage Above Normal, or Shorted to High Source. High signal voltage detected at the catalyst tank level sensor circuit.

Cummins ISB CM850 (2003-06) Fault Code: 1669 PID: SPN: 1761 FMI: 3 Catalyst Tank Level Sensor Circuit ? Voltage Above Normal, or Shorted to High Source. High signal voltage detected at the catalyst tank level sensor circuit.

The catalyst tank level sensor shares supply and return wires in the engine harness with other sensors. Opens and shorts in the engine harness can cause multiple fault codes to be active.

Before troubleshooting Fault Code 1669, check for multiple faults.

Possible causes:

1)Open return circuit in the harness, connectors, or sensor
2)Signal circuit shorted to sensor supply or battery voltage.

On-Board Diagnostics (OBD) Information (Euro 4 Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)The ECM turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail. The MIL lamp and fault code can also be cleared using the INSITE? service tool.
3)The fault code will be cleared from memory after 40 consecutive drive cycles where the diagnostic runs and passes.

On-Board Diagnostics (OBD) Information (Euro 4 Stage 1+ Certified Engines):

1)The ECM illuminates the malfunction indicator lamp (MIL) when the diagnostic runs and fails.
2)An engine torque derate will be activated after 50 hours of engine operation with the fault code active.
3)The ECM turns OFF the malfunction indicator lamp (MIL) after 1 ignition cycle that the diagnostic runs and does not fail. The MIL lamp cannot be cleared using the INSITE? service tool.
4)The fault code will be cleared from memory after 400 days or 9600 hours of engine operation.

Possible repairs:

1)Replace the catalyst tank level sensor.
2)The removal and reinstallation of the connector may correct the problem.
3)Repair or replace the engine harness.
4)Replace the ECM.