Cummins ISB CM550 (1990-94) Fault Code: 528 PID: 93 SPN: 93 FMI: 2 Alternate (Switched) Torque Curve Switch Circuit
Circuit Description
The torque curve switch circuit allows the operator to select from up to three preprogrammed
torque curves using a two- or three-position switch depending on which curve the original
equipment manufacturer (OEM) has provided.
Component Location
The location of the torque curve switch circuit varies with each OEM and equipment model.
Refer to the OEM manual.
Shop Talk
The switch should be monitored for proper operation in INSITE™. If the switch is changing
state correctly on the service tool, then the problem does not lie in the switch circuit. The
three-position switch has three states:
1) Position 1 – open
2) Position 2 – closed
3) Position 3 – 1500-ohm resistance.
The two-position switch has two states:
1) Position 1 – open
2) Position 2 – closed.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00
