Cummins ISB CM550 (1990-94) Fault Code: 516 PID: 91 SPN: 91 FMI: 4 Coolant Level Sensor Circuit
Circuit Description
The coolant level sensor monitors the coolant level within the coolant system and passes
information to the electronic control module (ECM) through the engine harness.
Component Location
The coolant level sensor is located in the radiator top tank or surge tank.
Shop Talk
This is an original equipment manufacturer (OEM)-supplied component and will vary in sensor
location.
1) If a shorting plug is used in the coolant level circuit, verify that it is wired correctly.
2) Inspect the wiring harness between the Weather-Pack four-way connector and the coolant level sensor for damage.
3) Make sure the coolant level sensor is located in the middle of the tank rather than off to
one side where the coolant level can change when the vehicle makes a turn.
Sterling trucks utilize ECM pin A22 for coolant level sensing through a 2-pin sensor.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00
