Cummins ISB CM550 (1990-94) Fault Code: 515 PID: 91 SPN: 91 FMI: 4 Coolant Level Sensor Circuit
Circuit Description
The coolant level sensor monitors the coolant level within the coolant system and passes
information to the electronic control module (ECM) through the engine harness.
Component Location
The coolant level sensor is located in the radiator top tank or surge tank.
Shop Talk
This is an original equipment manufacturer (OEM)-supplied component and will vary in sensor
location.
1) If a shorting plug is used in the coolant level circuit, verify that it is wired correctly.
2) Inspect the wiring harness between the Weather-Pack four-way connector and the coolant level sensor for damage.
3) Make sure the coolant level sensor is located in the middle of the tank rather than off to
one side where the coolant level can change when the vehicle makes a turn.
Sterling trucks utilize ECM pin A22 for coolant level sensing through a 2-pin sensor.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
