Cummins ISB CM550 (1990-94) Fault Code: 415-SN PID: 100 SPN: 100 FMI: 1 Oil Pressure – Engine Protection
Circuit Description
The oil pressure sensor is used by the electronic control module (ECM) to monitor the
lubricating oil pressure. The ECM monitors the voltage on the signal pin and converts this to a
pressure value. The oil pressure value is used by the ECM for the engine protection system.
Component Location
The oil pressure sensor is located on the engine block below the ECM.
Shop Talk
Verify, with the driver, the engine speed at which the fault occurs. If the engine is being
operated at too low of a speed, the oil pressure can drop below the engine protection limits.
Possible causes:
1) Low oil level
2) Low operation speeds
3) Oil dilution
4) Oil filters change
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00
