Cummins ISB CM550 (1990-94) Fault Code: 415-SN PID: 100 SPN: 100 FMI: 1 Oil Pressure – Engine Protection
Circuit Description
The oil pressure sensor is used by the electronic control module (ECM) to monitor the
lubricating oil pressure. The ECM monitors the voltage on the signal pin and converts this to a
pressure value. The oil pressure value is used by the ECM for the engine protection system.
Component Location
The oil pressure sensor is located on the engine block below the ECM.
Shop Talk
Verify, with the driver, the engine speed at which the fault occurs. If the engine is being
operated at too low of a speed, the oil pressure can drop below the engine protection limits.
Possible causes:
1) Low oil level
2) Low operation speeds
3) Oil dilution
4) Oil filters change
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
