Cummins ISB CM550 (1990-94) Fault Code: 381 PID: SID 237 SPN: 626 FMI: 11 Intake Air Heater Relay Circuit
Circuit Description
The intake air heater improves starting and white smoke control in cold ambient conditions.
The ECM controls relays that switch power to the air heater. There are two heating coils in the heater that are individually controlled by the ECM.
Component Location
The intake air heater is located at the air inlet connection into the intake manifold. The location of the heater relays will vary with the OEM.
Shop Talk
1) These faults could also indicate the intake air heater circuits are shorted to battery (+).
This would command the grids to be on full time. This will drain the batteries, burn out
grids, and/or destroy intake gaskets.
2) The intake air heater circuits will only activate when intake manifold temperature is below
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00
