Facebook-f Twitter Github Bitbucket
Shop
Account
Cart $570.00
3
3
Subtotal: $570.00
CLAAS MetaDiag 2007 Update 2016 is a crucial software tool for diagnosing issues in CLAAS agricultural machinery. It enhances efficiency and supports maintenance activities through advanced features and user-friendly design. This update includes improvements in diagnostic capabilities, compatibility, and installation processes. Designed for easy use, it is vital for technicians managing heavy machinery and trucks, ensuring optimal performance and reduced downtime.
CLAAS MetaDiag 2007 Update 2016
1 × $200.00
The ISUZU G-IDSS Domestic Japan 2024 is an advanced diagnostic tool designed for Isuzu vehicles. This version introduces several key features that enhance vehicle maintenance and streamline diagnostics. With improved user interfaces and multi-language support, technicians can efficiently navigate the system. The G IDSS also offers advanced programming capabilities, allowing for precise control updates and accurate diagnostics.
ISUZU G-IDSS Domestic Japan 2024 Diagnostic Software
1 × $220.00
Isuzu E-IDSS 2023 Diagnostic Software is designed for efficient diagnostics and repairs of Isuzu heavy machinery and trucks. It combines advanced technology with user-friendly features to facilitate accurate troubleshooting. The software supports a wide range of Isuzu models and enhances the repair process. Installation is straightforward and can be performed remotely via TeamViewer, ensuring quick setup for technicians.
Isuzu E-IDSS 2023 Diagnostic Software
1 × $150.00
Subtotal: $570.00
View cart Checkout

Cummins ISB CM550 (1990-94) Fault Code: 373 PID: 232 SPN: 1077 FMI: 3 Fuel Pump Fuel Shut Off Error

Circuit Description
This circuit provides a secondary fuel shutoff signal from the engine control module (ECM) to the fuel pump.

Component Location
The fuel pump is located on the back side of the gear housing.

Shop Talk
The fuel pump controller disables fuel injection if a greater-than-6-VDC signal is registered at pin 5 (pump connector end) for 1 second. This signal line is triggered if an engine protection limit is exceeded or if a pump controller defect is set.
Normal engine operation is as follows:
1) 0-VDC at pin 5 at keyswitch ON
2) 12-VDC at pin 5 at keyswitch OFF, until ECM powers down.
Check for a short circuit in the wiring harness, bad connectors, or high voltage at engine harness pin 5on the pump end at keyswitch ON.

Categories , , Tags , , , , , , , ,
Facebook Twitter Youtube
Wiring Diagrams
Component Locators

Related products