Cummins ISB CM550 (1990-94) Fault Code: 367 PID: 370 SPN: FMI: Fuel Pump Speed/Position Sensor Signal Lost
Circuit Description
This fault code indicates that the fuel pump speed/position signal is lost.
Component Location
The speed/position sensor is located in the fuel pump.
Shop Talk
The fuel pump determines its speed and position in relation to the engine by referencing an
internal tone wheel gap-analog signals are converted to digital.
If the digital signal is not available or if the gap of the incremental angle sensor tone wheel is
not recognized, the pump controller will set a fault code. Also, rapid speed changes, stalling,
or inlet pressure under 21 kPa [3 psi] can cause this fault code to set.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
-
-
