Cummins ISB CM550 (1990-94) Fault Code: 364 PID: SID 233 SPN: 1077 FMI: 9 Engine Control Module (ECM) to Pump Communications Error
Circuit Description
This circuit is used to communicate fueling, timing, and pump status messages between the ECM and pump controller. If this link is lost, the pump will operate in a backup mode based on the idle signal (pin 4).
Component Location
The datalink is located within the ECM and fuel pump control module.
Shop Talk
1) The datalink is used to communicate fueling and timing commands, as well as pump status
messages. If the datalink is lost, the pump will operate in backup mode based on idle signal (pin 4 at fuel pump connector).
2) This fault code will be active if the fuel pump power supply is inadequate.
3) When troubleshooting for this fault, suspect that one or a combination of the following can be the cause: The ECM, fuel pump, or wiring harness/fuses/relay.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0876 Transmission Reverse Pressure Switch Circuit Stuck Open
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00
