Cummins ISB CM550 (1990-94) Fault Code: 349 PID: 191 SPN: 191 FMI: 0 Auxiliary Speed or Auxiliary Pressure Input Error
Circuit Description
The auxiliary speed input is a frequency signal from an auxiliary speed or pressure pickup. It is sent to the electronic control module (ECM) and is used to control the engine speed. Auxiliary reference speed is based on the throttle position.
Component Location
The auxiliary speed or pressure pickup device location is dependent on the original equipment manufacturer’s (OEM) application. Refer to OEM troubleshooting and repair manual for
component location.
Shop Talk
The auxiliary speed governor controls engine speed based on a measured auxiliary speed or
pressure. The auxiliary speed governor feature must be enabled in the calibration and set
properly for speed or pressure, depending on the OEM application.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0218 Transmission Fluid Over Temperature Condition
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0848 Transmission Pressure Switch Solenoid D Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
