Cummins ISB CM550 (1990-94) Fault Code: 297 PID: 223 SPN: 1084 FMI: 3 OEM Pressure Sensor Circuit
Circuit Description
The OEM sensor signal is used by the electronic control module (ECM) to monitor the OEM
pressure. The OEM pressure is used by the ECM in one of two ways:1. The ECM can shut
down the engine based on an OEM pressure input value exceeding or falling below a
customer-specified value.2. The ECM can control a device (dual-output driver A and driver B)
based on the value of the OEM pressure.A sensor that has failed high can be caused by an
open circuit in the signal or return wire, voltage shorts in the signal or return wire, or a faulty
sensor.
Component Location
The location varies with the OEM. Refer to the OEM manual.
Shop Talk
The sensor voltage signal is the responsibility of the OEM. Refer to the OEM manual for specifications.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1041 J1850 (Class 2) ABS Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0873 Transmission Pressure Switch Solenoid E Circuit High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P2771 Four-Wheel Drive Switch Circuit
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1779 Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00
