Cummins ISB CM550 (1990-94) Fault Code: 278 PID: 73 SPN: 1075 FMI: 11 (Application for Trucks Other Than Ford) Lift Pump Circuit
Circuit Description
The electronic control module (ECM) enables the lift pump by sending a signal directly to the lift pump. The ECM fast-duty cycles the lift pump ON and OFF during cranking, and it enables the pump once the engine has started.
Component Location
The lift pump is mounted to the engine block on the intake side, toward the rear of the engine.
Shop Talk
1) The lift pump is turned ON for approximately 5 seconds when the keyswitch is first turned ON. With the hood raised, it is possible to hear the lift pump running when the keyswitch is turned ON.
2) Loose battery connections can sometimes cause this fault code.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1064 J1850 (Class 2) TBC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U0032 J1850 (Class 2) Serial Data Communication Link High
1000 & 2000 Gen 4 $50.00 -
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P0870 Transmission Pressure Switch Solenoid E Circuit
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
