Cummins ISB CM550 (1990-94) Fault Code: 261 PID: 168 SPN: 174 FMI: 0 Pump High Fuel Temperature Error/Overheat Error
Circuit Description
The fuel temperature sensor is located in the fuel pump. Fuel temperature information is
passed to the engine control module (ECM) through the controller area network datalink.
Component Location
The fuel temperature sensor is located in the fuel pump.
Shop Talk
This fault code is typically set when the fuel pump controller communicates to the ECM that the fuel temperature measured in the fuel inlet to the pump (temperature sensor) exceeds the allowable threshold value (93°C [199°F]). This signal does not set a final temperature defect in the controller and, in most cases, identifies a fuel overheat condition on the engine/vehicle.
Related products
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P1688 Unmanaged Engine Torque Delivered To TCM Signal
1000 & 2000 Gen 4 $50.00 -
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: P2773 Torque Control Request Ignored – ECM/TCM
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1300 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1096 J1850 (Class 2) IPC Controller State of Health Failure
1000 & 2000 Gen 4 $50.00 -
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
