Cummins ISB CM550 (1990-94) Fault Code: 143-SW PID: 100 SPN: 100 FMI: 1 Oil Pressure Switch Circuit
Circuit Description
The oil pressure switch is used by the engine control module (ECM) to detect the presence of
lubricating oil pressure.
Component Location
The oil pressure switch is located on the engine block, below and to the right of the ECM.
Shop Talk
1) Confirm that the oil pressure sensor supply voltage is between (+) 4.5 and 5.25-VDC at
the sensor.
2) Verify, with the driver, the engine speed at which the fault occurs. If the engine is being
operated at too low of a speed under load, the oil pressure can drop below the engine
protection limits.
3) Connect a manual gauge to monitor the actual oil pressure of the engine.
4) The fault will trigger if lubricating oil pressure drops below 41 kPa [6 psi] for 5 seconds
while the engine is operating.
5) Engines in the field can have had a jumper harness kit installed which connect the oil pressure switch to pin K in the 23-pin OEM connector or cavity 8 in the Ford original equipment manufacturer (OEM) connector.
Related products
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0123 Pedal Position Sensor Circuit High Voltage
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: P0122 Pedal Position Sensor Circuit Low Voltage
1000 & 2000 Gen 4 $50.00 -
Bendix ABS EC-30 Fault Code: SID 251 FMI 3
Bendix ABS -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1301 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
Allison 1000 & 2000 Gen 4 Fault Codes: U0031 J1850 (Class 2) Serial Data Communication Link Low
1000 & 2000 Gen 4 $50.00 -
-
-
-
-
-
Allison 1000 & 2000 Gen 4 Fault Codes: U1000 Class 2 Loss of Serial Data Communication
1000 & 2000 Gen 4 $50.00 -
