CAT 3406E (Prefix 5DS or 1LW) Fault Code: 42 PID: 22 SPN: FMI: 13 Engine Speed Signal Calibration Not Performed
The Engine Control Module (ECM) detects the following conditions:
•A timing calibration has never been performed on a new ECM or the timing is off by more than three degrees.
Probable Causes:
1) Speed/timing sensor not calibrated properly (Need CAT software to do this)
2) Speed/timing sensor failure
3) Speed/timing sensor harness failure
![JOHN DEERE PARTS ADVISOR & HITACHI 2.24.2 [2023.07] - ECUFORCETRUCK EPC](https://www.ecuforcetruck.com/wp-content/uploads/2023/09/1-300x300.png)
![Volvo Penta EPC 6 Offline VMware [12.2021] VMware](https://www.ecuforcetruck.com/wp-content/uploads/2022/11/VOLVO-PENTA-2021-A-300x300.jpg)
