CAT 3406E (Prefix 5DS or 1LW) Fault Code: 36 PID: 84 SPN: FMI: 8 Vehicle Speed signal out of range
The Engine Control Module (ECM) detects the following conditions:
•The vehicle speed signal indicates that vehicle speed is greater than 127.5 MPH for more than two seconds.
•The “VSL Protection” parameter is programmed to a value that is less than 2120 rpm.
Probable Causes:
1) Fuel system restriction (Uncommon, but possible)
2) If speedometer is not accurate, then ECM is not programmed correctly
3) Vehicle speed sensor
4) Vehicle speed sensor wiring
5) ECM Connection/Harness
6) Speedometer failure
7) ECM Failure
-
Bobcat Service Library [03.2019] Service, Operator, Maintenance, Bulletines, etc full update
Bobcat $110.00Rated 0 out of 5 -
Hino Diagnostic eXplorer 2 – Hino DX2 1.1.19.1 with keygen unlocked ( Hino trucks )
Hino $50.00Rated 0 out of 5 -
download MANCATS II v14.01 2014 Diagnostic software MAN CATS ( virtual machine )
MAN $75.00Rated 0 out of 5
Related products
-
CAT 3126B Fault Code: 231-11 PID: Flash Code 58 SPN: 639 FMI: 12 J1939 Data Link Fault
3126BRated 0 out of 5 -
CAT 3126B Fault Code: 111-11 PID: Flash Code 62 SPN: 111 FMI: 18 Low Coolant Level Warning
3126BRated 0 out of 5 -
CAT 3126B Fault Code: 168-00 PID: Flash Code 51 SPN: 168 FMI: 0 Excessive ECM Battery Power
3126BRated 0 out of 5 -
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT $65.00Rated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5
-
SERVICE MANUAL DETROIT DIESE LDDEC VI – CPC Vehicle Interface Harness Schematic
DETROIT $15.00Rated 0 out of 5 -
MANUAL SERVICE Deutz Combine 5650 H, 5660 HTS5670 H / HTS5680 H, 5690 HTS
DEUTZ $38.00Rated 0 out of 5