CAT 3406E (Prefix 5DS or 1LW) Fault Code: 00 PID: 171 SPN: FMI: 4 Ambient Air Temperature voltage low
The Engine Control Module (ECM) detects the following conditions:
•The signal voltage from the ambient air temperature sensor is less than 0.2 VDC for more than eight seconds.
•The “Allow Idle Shutdown Override” parameter is programmed to “Outside Temperature Based” or “J1587 Outside Temperature Based”.
•The ECM has been powered for at least two seconds.
Probable Causes:
1) ECM Connection/Harness
2) If code 232-3 or 232-4 (5 Volt Supply voltage codes) are active, troubleshoot those instead
3) Temperature sensor failure
4) Temperature sensor harness
5) ECM Failure
-
Bobcat Service Library [03.2019] Service, Operator, Maintenance, Bulletines, etc full update
Bobcat $110.00Rated 0 out of 5
Related products
-
CAT 3126B Fault Code: 168-01 PID: Flash Code 51 SPN: 168 FMI: 1 Low ECM Battery Power
3126BRated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
CAT 3126B Fault Code: 252-11 PID: Flash Code 59 SPN: 631 FMI: 11 Incorrect Engine Software
3126BRated 0 out of 5 -
CAT 3126B Fault Code: 168-00 PID: Flash Code 51 SPN: 168 FMI: 0 Excessive ECM Battery Power
3126BRated 0 out of 5
-
SERVICE MANUAL INTERNATIONAL ENGINE VT365 (2004 & Newer)
INTERNATIONAL ENGINES $24.00Rated 0 out of 5 -
SERVICE MANUAL INTERNATIONAL ENGINE VT275 (2005 & Newer)
INTERNATIONAL ENGINES $27.00Rated 0 out of 5