CAT 3406E (Prefix 1MM or 2WS) Fault Code: 31 PID: SPN: 84 FMI: 1 Vehicle Speed loss of signal
The ECM detects the following conditions:
•The vehicle speed signal indicates that the vehicle speed is 0 MPH.
•Desired engine speed is greater than the programmed “VSL Protection”.
•The “VSL Protection” parameter is programmed to a value that is less than 2120 rpm.
Probable Causes:
1) Fuel system restriction (Uncommon, but possible)
2) If speedometer is not accurate, then ECM is not programmed correctly
3) Vehicle speed sensor
4) Vehicle speed sensor wiring
5) ECM Connection/Harness
6) Speedometer failure
7) ECM Failure
![DOOSAN DMS-5 3.1.3 [2023.11] diagnostic software](https://i0.wp.com/www.ecuforcetruck.com/wp-content/uploads/2023/11/1.png?resize=300%2C300&ssl=1)
