CAT 3406E (Prefix 1MM or 2WS) Fault Code: 29 PID: SPN: 30 FMI: 13 PTO Throttle out of calibration
The Engine Control Module (ECM) detects the following conditions:
•The duty cycle of the signal for the PTO throttle is less than 5 percent or more than 95 percent for more than two seconds.
•The PTO Configuration is programmed to “Remote Throttle”.
•The ECM has been powered for at least three seconds.
Probable Causes:
1) ECM Connection/Harness
2) Accelerator Position Sensor
3) Accelerator Position Sensor Harness
4) ECM Failure
-
ddct Detroit diesel calibration tool (DDCT) v4.5 English Include Calibrations & Metafiles
Detroit $30.00Rated 0 out of 5 -
CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10
CAT $45.00Rated 0 out of 5
Related products
-
CAT CDVR PC Software – Caterpillar Digital Voltage Regulator (CDVR) WINDOWS 10
CAT $45.00Rated 0 out of 5 -
CAT 3126B Fault Code: 70-05 PID: Flash Code 49 SPN: 729 FMI: 5 Inlet Air Heater Open Circuit
3126BRated 0 out of 5 -
CAT Engine Reprogramming Tool for flash programming C1.8, C2.4, C3.8 & C3.3B + Guide
CAT $50.00Rated 0 out of 5 -
CAT 3126B Fault Code: 111-11 PID: Flash Code 62 SPN: 111 FMI: 18 Low Coolant Level Warning
3126BRated 0 out of 5 -
10 IN 1 FOR CAT SIS Caterpillar 2021 Full Service Dealer INCLUDING CAT 2019 C
CAT $110.00Rated 0 out of 5
-
SERVICE MANUAL DETROIT DIESEL DDEC III-IV Single ECM Troubleshooting Guide
DETROIT $48.00Rated 0 out of 5